Name: CCTV and Alarm System

Text: G OVE RNM E NTAL

SE CU RITY

S OL UT I O N S

Product Information

Portable VIP Protection 2
CCTV & Alarm System

VIP KIT
Rapid Deployment VIP Protection Kit

The VIP KIT has been designed to provide rapidly deployable CCTV and intrusion
detection for all types of mobile operations.
The VIP KIT is a modular system that can be configured according to customer
demands and situations.
The standard model includes the following:
Fully programmable and portable, ruggedized monitoring case
4 x Audio/Video Receivers
4 x Wireless and battery powered “Day/Night” camera units
4 x Wired and battery powered “Day/Night” camera units
4 x Wireless and battery powered PIR detector units
4 x Wireless and battery powered Door Contact units
1 x Fully programmable Digital Video Recorder with removable 80Gb
hard disk
1 x 8” TFT Monitor connected to fully adjustable Quad multiplexer
1 x 8” TFT Monitor connected to DVR for full Video playback
1 x Remote control handset for remote activation of cameras
Battery packs and chargers for all wireless items (12 units)
The VIP KIT can be configured for any of the following options:
Customer specified cameras with PTZ or other options
GSM/SMS alert module
Video encryption modules
Audio encryption modules
Smoke/Fire wireless detection units or any other form of sensor.

CONFIDENTIAL

page 2

Specifications
Receivers
4 Receivers individually programmable to supplied transmitter frequencies, ranging
from 900 – 2.2GHz with LowPas Filters to cut out unwanted interference.

Antenna Connectors

Signal Meter

Frequency Adjustment

LNB On/Off
Receiver Power On/Off

Frequency range
Programmable steps
Noise
Input impedance
IF bandwidth
Video deviation
Video output
De-emphasis
Video frequency response
Differential gain
Differential phase
Video S/N ratio
Audio sub-carrier frequency
Audio sub-carrier deviation
Audio de-emphasis
Audio frequency response
Audio output
Audio S/N ratio
Working Temperature

900MHz–2200MHz (PLL)
1MHz digital
10db
75W connector F female
27/16MHz SAW filter 479.5MHz
±4MHz (±8.5MHz max), +ve/-ve switchable
1Vpp on 75W adjustable (PAL, NTSC or SECAM)
standard CCIR switchable
50Hz–5MHz ±1dB with audio at 7.5MHz, ±2dB
with audio at 5.5MHz
±4%
±4% >40dB
unweighted deviation, = 4MHz RF input 50dBm
unweighted deviation, = 4MHz RF input 50dBm
±50kHz
50ms
15kHz–15MHz ±3dB
0dBm on 1kW adjustable
>45dB unweighted
0–45°C

CONFIDENTIAL

page 3

Wireless Camera Units
The camera units are installed with Day/Night cameras, 100Mw transmitters
(higher power can be requested). Each unit has 10 channels to avoid frequency
conflict. The cameras are programmed to remain in stand-by until alarm is received
or remote control signal is received to switch them on. With the supplied battery
pack, the cameras will remain powered for up to 6 months in stand-by mode.

Remote Control Antenna
Transmitter Antenna

Camera Lens

Audio Mic Connector
Mains/Battery Connector

Camera
Working Frequency
RF Power Output
RF power impedance
Frequency Stability
Video Carrier Deviation
Video input level
Video frequency response
Audio sub-carrier frequency
Audio sub-carrier deviation
Audi frequency response
Audio input level
Dimensions
Working Temperature
Weight
Audio Connector
Supply connector

CONFIDENTIAL

4mm Lens Day Night Colour Camera
(NTSC or PAL)
900MHz – 2200Mhz 10 Channel

100mW ±1dB
50W (SMA)
±300kHz
±4MHz (FM)
1Vpp adj. 75W (BNC)
50Hz–5MHz +0/-2dB
1.5MHz–7.5MHz
±50kHz FM
20Hz–15kHz ±3dB
LINE 100mV into 5KW MIC input
20mV
52mm x 64mm x 23mm
-10/+50°C
150g
RCA female
3 pin direct insertion

page 4

Digital Video Recorder
The DVR is supplied with removable 80Gb hard disk. All functions are controlled
from the touch screen panel. The DVR is installed in series with the 8” TFT
playback screen and the camera connections. The DVR can be programmed to
automatically record all alerts each time the video cameras are enabled.

Removable Hard Drive

Touch Screen Control

Technical Specifications
Video Input:
One MiniDin 4 Pin connector
Analogue Input Composite and S-Video (Y/C), software selectable.
Level 1.0 Vp-p 75 ohms
PAL and NTSC standards, 625/50 (PAL) 525/60 (NTSC)
Pixel Resolution: 720 x 576 pixels (PAL), 720 x 486 (NTSC)
ADC:
Sampling: 13.5MHz
S/N Ratio 50db
Bandwidth: 7 MHz (-3db)
Differential Gain: 2%
Differential Phase: 2 deg.
ADC Differential Linearity: +/- 0.7 LSB
ADC Integral Linearity: +/- 1.0 LSB

CONFIDENTIAL

page 5

Video Output:
One MiniDin 4 Pin Connector
Analogue output composite and S-Video (Y/C), software selectable.
PAL and NTSC standards 625/50 (PAL) 525/60 (NTSC)
Level 1.0 Vp-p 75 ohms
550 lines resolution
DAC:
- High Quality 10-Bit Video DACs
- Integral Nonlinearity < 1 LSB at 10 Bits
- 80 db Video SNR
Video Compression:
Wavelet codec for superior image quality
Real time compression or decompression at 720 x 288 @ 50 fields/sec –
PAL
720 x 240 @ 60 fields/sec – NTSC
Visually Loss-less compression at 4:1 on natural images
Compression ratio variable down to 4:1
Field rate variable from 50 fields/sec to 1 fields/sec PAL. (60 fields/sec to 1
fields/sec NTSC)
Audio Input:
One 3.5mm stereo jack
Level Max 1 volt RMS 12 Kohm input impedance.
Resolution 16 bits, sampling rate 39375 KHz
Audio Output:
One 3.5mm stereo jack
Headphone amplified output 82mW on 32 ohm, THD=0.1% (max) f=1 kHz
Digital db-linear volume control
Power Input:
Power jack 2.1mm
Power requirement 12 volt at 500 ma while recording.

CONFIDENTIAL

page 6

GPI Input:
One 2.5mm stereo jack
22 Kohm pulldown input resistance, digital level.
+5 volt max 20ma available.
Infrared Receiver:
38 Khz receiver compatible with RC5 standard.
Serial Port:
One 3.5mm stereo jack
Three pin RS232 (TX, RX, GND) serial port.
Programmable speed to max 115200 Baud.
Hardware:
Processor 32 bit RISC ARM ARM7TMDI core, clock speed 75.6MHz.
1 Mb flash memory, 256 bytes Flash EEPROM
32 Mb SDRAM
LCD display 240 x 320 pixel touch panel and backlight
2.5” removable hard disk maximum size of 60Gb.
PIO mode 4 protocol with maximum data rate of 16.6Mb/Sec.

CONFIDENTIAL

page 7

Wireless Sensor Units
The VIP KIT will operate with up 8 remote wireless sensors. Standard supply is 4 x
PIR units and 4 x Door Contact units. Alternative sensors can be supplied upon
request.
Each wireless unit is supplied with fully rechargeable battery packs giving up to 3
days power, transmitting on or around 836MHz frequency.
All sensors are directly controlled by the Master Wireless Communication Station
installed in the control case. The MWCS will communicate every 3 seconds with
the remote sensors, interrogating each unit for details of Battery level,
Temperature and Signal Strength. Any change below accepted thresholds will set
of the system alarm.
When the alarm signal is received and status of the MWCS advises anything other
than battery loss, the remote control can be pressed to automatically switch on the
cameras in the required area. If the system alarm is not attended to within 20
seconds, the cameras will automatically switch on and the DVR will automatically
start to record.
An optional GSM module can be installed to allow transmission of alarm status by
SMS to pre-programmed cellular number.

Antenna
Connector
Alert
Display
Panel

Power Status

TX/RX Status

Setting
Switches

Sound Alert
On/Off

CONFIDENTIAL

page 8

Wireless PIR

Built In TFT Monitors

CONFIDENTIAL

page 9

Audio Control & External Wired Cameras
The system is built to accept 4 external wired camera units. The system will
display, either the Wireless or the Wired cameras through the built in Quad
Multiplexer and built in TFT monitor.
To monitor 8 cameras, an external monitor can be used and connected to the
system through an external switcher attached to the built in BNC Video Output
sockets.
All Audio is controlled through the case mounted panel. Individual channels can be
opened or closed for real time listening and DVR audio controls can also be
adjusted from this panel.

Wired Video and Audio Control Panel

CONFIDENTIAL

page 10

S OL UT I O N S
S ECU RITY
GOVE RNM E NTA L

If you would like further Information about ELAMAN,
or would like to discuss a specific requirement or project, please contact us at:
Elaman GmbH
German Security Solutions
Seitzstr. 23
80538 Munich
Germany
Tel: +49-89-24 20 91 80
Fax: +49-89-24 20 91 81
info@elaman.de
www.elaman.de

Document Path: ["vip-protection-cctv-amp-alarm-system-2.pdf"]

e-Highlighter

Click to send permalink to address bar, or right-click to copy permalink.

Un-highlight all Un-highlight selectionu Highlight selectionh